Skip to content

flat(tish) carbuncles

first attempt with flat wire. hand wound round a rod…3.5mm ID approximately. 316L with 5 wraps each coming out at 0.3 ohms. not the neatest work i've ever done as you can see here on the bonza (must swap out those flat-head screws!). the 'slight' spacing works well in temp control though

<a href="https://www.e-cigarette-forum.com/forums/coil-builds.836/media/431207/”>

Post a Comment

Your email is never published nor shared. Required fields are marked *
*
*